Matrix elements gt1000 fx ( etapa FRFR para fractal, quad cortex ,etc )

Muy buenas,

Vendo etapa Matrix Elements GT1000FX ideal para amplificar cualquier modelador tipo Fractal audio , Quad cortex, Kemper , etc, tipo FRFR cuando se desea una respuesta plana y sin ningún colorido usando pantallas tradicionales.


Dejo las características por aquí para los interesados

2.1 Technical Specifications
GT 1000FX 2U
Number of Channels: 2
Watts Per Channel at - 16 Ω: 150
Watts Per Channel at - 8 Ω: 300
Watts Per Channel at - 4 Ω: 500
Watts Bridged (A and B) - 16 Ω: Watts Bridged (A and B) - 8 Ω: Supply Voltage: 230V +/- 15%
Average Supply Current, Full Load: 650
1000
5A
Mains Connector: 10A IEC
Frequency Response: 8–24,000 Hz
Signal to Noise Ratio
96 dB
(ref. Full power 1kHz):
THD (1kHz, full power): 0.06%
THD (20Hz - 20kHz, full power): <0.1%
Slew Rate: 50 V/µs
Damping Factor (ref. 8R, 100Hz): >400
Cooling Fan Arrangement:
1x 80mm
(Temperature controlled dual speed fans)
Input Level Sensitivity: 0.775v / 0 dBu
Dimensions (mm): 482 X 44 X 210
Weight: 5.0 Kg

Amplifier features:
• Design Optimised for Guitar Amplification.
•
• Class AB, MOSFET amplifier topology.
..
• An unprecedentedly powerful and stable Switch Mode Power Supply.
Designed without compromise, to exceed the performance of the previous linear supply
models; whilst offering a weight advantage rarely seen even in other SMPS amplifiers.
.
• Soft Start Circuit.
The power supply is designed not to draw excessive current on startup - Prevents the 'thump'
as occasionally occurs with other equipment, from tripping fuses and breakers.
.
• Protection against Short Circuit and Overheating.
.
• Speaker Protection relay with delay to inhibit switch on thump.
The speakers are disconnected during power up/down.
• Fully balanced XLR Inputs, which also accept 1/4” jack connectors..
• Speakon / 1/4” Jack Combi Outputs.
•
.
.
Expanded output options for guitar amplifier use.
• Stereo, Mono and Bridged (Mono) Modes selectable via rear panel switches.
Mode of operation indicated on front panel LED status display.
.
• In Mono Mode, only input A is used to feed channel pair A and B. Independent
control of each channel's output level remains functional.
.
• Temperature regulated, Low Speed Fan Cooling.
A low noise fan is utilised in this model to facilitate use in low background noise
environments, such as studios. (The amplifier vents hot air through rear connector panel).
.
• 0.775v / 0 dBu Inputs.
Input level optimised for guitar amplifier use.
.
• 2U Case Format.
A standard amplifier format case to permit the use of a lower noise cooling solution.



La etapa esta en perfecto estado tanto de funcionamiento como estéticamente , básicamente como si la compraras nueva .
Tengo los papeles que venían con ella .
Ahora mismo esta montada en un rack de 2 espacios el cual puedo incluir con un pequeño ajuste en el precio si el comprador desea quedárselo también tal cual sale en las fotos .
Se puede probar sin compromiso en Madrid .

Precio: 550 €

Un saludo y gracias .